How to run the "Identify Variants" ready-to-use workflow

  1. Go to the toolbox and double-click on the "Identify Variants" ready-to-use workflow (figure 15.1).

    Image run_identify_variants_tas
    Figure 15.1: The ready-to-use workflows are found in the toolbox.

    This will open the wizard shown in figure 15.2 where you can select the sequencing reads from the sample that should be analyzed.

    Image identify_variants_wizardstep1_tas
    Figure 15.2: Please select all sequencing reads from the sample to be analyzed.

    Select all sequencing reads from your sample. If several samples should be analyzed, the tool has to be run in batch mode. This is done by selecting "Batch" (tick "Batch" at the bottom of the wizard as shown in figure 15.47) and select the folder that holds the data you wish to analyze. If you have your sequencing data in separate folders, you should choose to run the analysis in batch mode.

    When you have selected the sample(s) you wish to prepare, click on the button labeled Next.

  2. In this wizard you can restrict calling of InDels and structural variants to the targeted regions by specifying the track with the targeted regions from the experiment (figure 15.3).

    Image identify_variants_wizardstep2_tas
    Figure 15.3: Select the track with the targeted regions from your experiment.

  3. In the next wizard step (figure 15.4) you have to specify the track with the targeted regions from the experiment. You can also specify the minimum read coverage, which should be present in the targeted regions.

    Image identify_variants_wizardstep3_tas
    Figure 15.4: Select the track with the targeted regions from your experiment.

  4. Click on the button labeled Next, which will take you to the next wizard step (figure 15.5). In this wizard you can specify the parameter for detecting variants.

    Image identify_variants_wizardstep4_tas
    Figure 15.5: Please specify the parameters for variant detection.

  5. Click on the button labeled Next, which will take you to the next wizard step (figure 15.6).

    Image identify_variants_wizardstep5_tas
    Figure 15.6: Select the targeted region track. Variants found outside the targeted region will be removed.

  6. Click on the button labeled Next to go to the last wizard step (figure 15.7).

    Image identify_variants_wizardstep6_tas
    Figure 15.7: Choose to save the results. In this wizard step you get the chance to preview the settings used in the ready-to-use workflow.

    In this wizard you get the chance to check the selected settings by clicking on the button labeled Preview All Parameters. In the Preview All Parameters wizard step you can only check the settings, it is not possible to make any changes at this point. At the bottom of this wizard there are two buttons regarding export functions; one button allows specification of the export format, and the other button (the one labeled "Export Parameters") allows specification of the export destination. When selecting an export location, you will export the analysis parameter settings that were specified for this specific experiment.

  7. Click on the button labeled OK to go back to the previous wizard step and choose Save.

    Note! If you choose to open the results, the results will not be saved automatically. You can always save the results at a later point.