Extending the pre-defined list of primer additions

The list of primer additions shown when pressing Shift+F1 (on Mac: Shift + fn + F1) in the dialog shown in figure 30.15 can be configured and extended. If there is a tag that you use a lot, you can add it to the list for convenient and easy access later on. This is done in the Preferences:

        Edit | Preferences | Advanced

In the advanced preferences dialog, scroll to the part called Gateway cloning primer additions (see figure 30.21).

Image gateway_cloning_preferences
Figure 30.21: Configuring the list of primer additions available when adding attB sites.

Each element in the list has the following information:

Name
The name of the sequence. When the sequence fragment is extended with a primer addition, an annotation will be added displaying this name.
Sequence
The actual sequence to be inserted. The sequence is always defined on the sense strand (although the reverse primer would be reverse complement).
Annotation type
The annotation type used for the annotation that is added to the fragment.
Forward primer addition
Whether this addition should be visible in the list of additions for the forward primer.
Reverse primer addition
Whether this addition should be visible in the list of additions for the reverse primer.

You can either change the existing elements in the table by double-clicking any of the cells, or you can use the buttons below to: Add Row or Delete Row. If you by accident have deleted or modified some of the default primer additions, you can press Add Default Rows. Note that this will not reset the table but only add all the default rows to the existing rows.