On macOS the server can be started and stopped from the command line.

Open a terminal and navigate to the CLC Server installation directory. Once there, the server can be controlled with the following commands.

Remember to replace CLCServer, in the commands listed below, with the name from the CLC Genomics Server: CLCGenomicsServer

To start the server run the command:

sudo ./CLCServer start

To stop the server run the command:

sudo ./CLCServer stop

To view the current status of the server run the command:

sudo ./CLCServer status

You will need to set this up as a service if you wish it to be run that way. Please refer to your operating system documentation if you are not sure how to do this.

Once your server is started, you can use the Admin tab on the server web interface to manage your server operation (see section 7).