Track view
The Track view of the Genotype track has the following options in the Track layout side panel:
- Data aggregation
- Allows you to specify whether the information in the track should be shown in detail or whether you wish to aggregate data. By aggregating data you decrease the detail level but increase the speed of the data display process, which is of particular interest when working with big data sets. The threshold (in bp) for when data should be aggregated can be specified with the drop-down box. The threshold describes the unit (or "bucket") size in base pairs, above which the data will start being aggregated. The bucket size depends on the track length and the zoom level. Hence, a data aggregation threshold with a low value will only show details when zoomed in, whereas a high value means that you can see details even when zoomed out. Please note that when using the high values, it will take longer time to display the data on the screen.
- Show filtered
- When enabled, alleles with applicable filters will be shown crossed out. Filtered alleles are hidden as default.
- Reference alleles
- Show reference alleles in a dimmed color to make them more distinguishable.
- View mode
- The view mode allows selection of whether to display overlap alleles of complex loci.
- Haplotypes Haplotypes are displayed as linked haplotype alleles, and overlap alleles are not shown. Annotation and filter details are available in the tooltip when hovering over a haplotype allele.
- Inspection Overlap alleles are shown. Haplotype details are not available in this view mode.
- Annotation color
- Makes it possible to change the allele color.