Options for clc_assembler 

usage: clc_assembler [options]
  Assemble some reads and output contig sequences in fasta format.
Options:
  -h / --help: Display this message
  -q / --reads: The files following this option are read files. Fasta, fastq,
     and sff formats are allowed. (may be used several times)
  -i <file1> <file2> / --interleave <file1> <file2>: Interleave the sequences
     in two files, alternating between the files when reading the
     sequences. Only valid for read files. (may be used several times)
  -o <file> / --output <file>: Give the output fasta file (required)
  -f <file> / --feature_output <file>: Output scaffolding annotation in
     GFF (default) or AGP format. The file suffix is used to determine the
     output format. Use '.gff' for GFF format and '.agp' for AGP format.
  -m <n> / --min-length <n>: Set the minimum contig/scaffold length to output
     (default = 200)
  -w <n> / --wordsize <n>: Set the word size for the de Bruijn graph (default
     is automatic based on input data size)
  -b <n> / --bubblesize <n>: Set the maximum bubble size for the de Bruijn graph
     (default is 50)
  --cpus <n>: Set the number of cpus to use.
  -v / --verbose: Output various information while running.
  -p <par> / --paired <par>: Set the paired read mode for the read files
     following this option. (may be used several times)
     par consists of four strings: <mode> <dist_mode> <min_dist> <max_dist>
     mode is ff, fb, bf, bb and sets the relative orientation of read one and
     two in a pair (f = forward, b = backward)
     dist_mode is ss, se, es, ee and sets the place on read one and two to
     measure the distance (s = start, e = end).
     A typical use would be "-p fb ss 180 250" which means that the reads are
     inverted and pointing towards each other. The distance includes both the
     reads and the sequence between them. The distance may be between 180 and
     250, both included.
     It is also allowed to insert a "d" before the mode. This indicates that
     the reads in the following file(s) should only be used for their paired end
     information and not to build initial contigs. E.g. "-p d fb ss 180 250".
     To explicitly say that the following reads are not paired, use "no" for
     par, i.e. "-p no".
     For paired end reads split in two files, use the -i option.
  -e <file> / --estimatedistances <file> Estimate paired distances for all paired
     reads and save the distance estimates in <file>. If it is not possible to
     get an accurate distance estimate for a file, the original paired distance
     is used.
  -g <mode> / --fragmentmode <mode>: Set the mode for how reads are used to
     create fragments. One mode is "ignore", which ignores the nucleotides
     when building initial fragments. The other mode is "use", which uses
     the nucleotides when building initial fragments. This is the default mode.
     The mode applies to all read files following this option. The option may be
     used repeatedly.
  -n / --no-scaffolding: Pair info is used for contig creation, but no
     scaffolding is performed.
Examples:
  Assembly of a single file with reads:
    clc_assembler -o contigs.fasta -q reads.fasta
  Assembly of two interleaved files with paired end reads:
    clc_assembler -o contigs.fasta -p fb ss 180 250 -q -i reads1.fq reads2.fq