Reverse sequence
CLC Sequence Viewer is able to create the reverse of a
nucleotide sequence.
Note! This is not the same as a reverse complement. If you wish to create the reverse complement, please refer to Create Reverse Complement.
To run the tool, go to:
Toolbox | Nucleotide Analysis (
)| Reverse Sequence (
)
This opens the dialog displayed in figure 10.4:
Figure 10.4: Reversing a sequence.
If a sequence was selected before choosing the Toolbox action, the sequence is now listed in the Selected Elements window of the dialog. Use the arrows to add or remove sequences or sequence lists from the selected elements.
Click Finish to start the tool.
Note! This is not the same as a reverse complement. If you wish to create the reverse complement, please refer to Create Reverse Complement.