Create experiment

The Create experiment step is for setting up differential expression analysis for groups of samples based on sample metadata. A brief description is below. Please refer to the Create experiment dialog section later in this manual for details.

Image createexperiment1
Figure 11: On page 1 of the Create experiment dialog you select project and samples.

  1. Click on the Create experiment button at the top of the Analysis Portal page. Alternatively, go into the project you selected in the Align and count dialog and click on Create experiment there. This opens the Create experiment dialog (figure 11).
  2. Select the project with the samples to be analyzed. If you clicked Create experiment from within a project, that project will be preselected.
  3. Define a subset of the project samples by selecting the relevant Vendor, Sample kit and Reference.
    It is only possible to run differential expression analyses using samples analyzed with the same sample kit and reference settings.
  4. From the subset now listed in the bottom half of the dialog, select the samples to analyze.
  5. Click on Next to go to step 2 of the dialog. At the top, your settings and sample selection from the first step are summarized (figure 12).
  6. Fill in the Experiment name and Experiment description fields.
  7. Define the sample grouping, either by adding a sample metadata file, or by adding attributes and values manually. Samples can be divided into groups based the values of each attribute.

In the Experimental design section, specify the details of the analysis.

  1. In the Test differential expression due to drop-down menu, select the attribute to test for expression effects. In figure 12, we selected Tissue.
  2. In the While controlling for drop-down menu, you can select an attribute to correct for. In figure 12, we did not select an attribute to correct for.
  3. In the Experimental setup (comparisons) drop-down menu, select the type of comparison to run:
    • Across groups (ANOVA-like)
    • All group pairs
    • Against control group
In the example shown in figure 12, the choice of attribute Tissue results in the six selected samples being put in two groups based on the values of that attribute, Normal and Tumor.
  1. If you selected Against control group, you need to specify a control group attribute value, i.e. the group to compare the remaining groups to. In figure 12 we selected Normal for the control group.
  2. Click on Start.

Image createexperiment2
Figure 12: In Create experiment dialog page 2 you define how samples should be compared.

Your experiment will now be created and will be listed under the specified project.

When the analysis is complete, the status of the Experiment overview changes from In progress... to Done and an additional tile, Experiment summary and QC, is added.

Depending on your preferences, you will receive an email notification when your experiment is done, see Email notification setup in the User Interface chapter.

Results of the differential expression analyses can now be inspected and refined.