Extract parts of a contig

Sometimes it is useful to extract part of a contig for in-depth analysis. This could be the case if you have performed an analysis of a whole genome data set and have found a region that you are particularly interested in analyzing further. Rather than running all further analysis on your full data, you may prefer to run only on a subset of the data. You can extract a subset of your contig data by running the Extract from Selection tool on a selected region in your contig. The result of running this tool is a new contig which contains only the reads (and optionally only those that are of a particular type) in your selected region.

To select a region, use the Selection mode (Image selection) (see Section 2.2.3 for a detailed description of the different modes) and select you region of interest in your contig, then right-click. You are now presented with the dialog shown in Figure 18.23.

Image extractfromselection
Figure 18.23: Extracting parts of a contig.

When you choose the Extract from Selection option you are presented by the dialog shown in figure 18.24.

Image open_new_contig_from_selection_step1
Figure 18.24: Selecting the reads to include.

The purpose of this dialog is to let you specify what kind of reads you want to include. Per default all reads are included. The options are:

Paired status
Include intact paired reads
When paired reads are placed within the paired distance specified, they will fall into this category. Per default, these reads are colored in blue.
Include paired reads from broken pairs
When a pair is broken, either because only one read in the pair matches, or because the distance or relative orientation is wrong, the reads are placed and colored as single reads, but you can still extract them by checking this box.
Include single reads
This will include reads that are marked as single reads (as opposed to paired reads). Note that paired reads that have been broken during assembly are not included in this category. Single reads that come from trimming paired sequence lists are included in this category.
Match specificity
Include specific matches
Reads that only are mapped to one position.
Include non-specific matches
Reads that have multiple equally good alignments to the reference. These reads are colored yellow per default.
Alignment quality
Include perfectly aligned reads
Reads where the full read is perfectly aligned to the reference sequence (or consensus sequence for de novo assemblies). Note that at the end of the contig, reads may extend beyond the contig (this is not visible unless you make a selection on the read and observe the position numbering in the status bar). Such reads are not considered perfectly aligned reads because they don't align in their entire length.
Include reads with less than perfect alignment
Reads with mismatches, insertions or deletions, or with unaligned nucleotides at the ends (the faded part of a read).
Spliced status
Include spliced reads
Reads that are across an intron.
Include non spliced reads
Reads that are not across an intron.
Note that only reads that are completely covered by the selection will be part of the new contig.

One of the benefits of this is that you can actually use this tool to extract subset of reads from a contig. An example work flow could look like this:

  1. Select the whole reference sequence
  2. Right-click and Extract from Selection
  3. Choose to include only paired matches
  4. Extract the reads from the new file (see Extract sequences)
You will now have all paired reads from the original mapping in a list.