Reverse sequence

CLC Main Workbench is able to create the reverse of a nucleotide sequence.

Note! This is not the same as a reverse complement. If you wish to create the reverse complement, please refer to Create Reverse Complement.

To run the tool, go to:

        Toolbox | Nucleotide Analysis (Image nucleotideanalyses)| Reverse Sequence (Image reversecomplement)

This opens the dialog displayed in figure 16.4:

Image reversesequence
Figure 16.4: Reversing a sequence.

If a sequence was selected before choosing the Toolbox action, the sequence is now listed in the Selected Elements window of the dialog. Use the arrows to add or remove sequences or sequence lists from the selected elements.

Click Finish to start the tool.

The Reverse Sequence tool will output reversed sequences holding the input sequences name with a "-R" suffix.

Note! This is not the same as a reverse complement. If you wish to create the reverse complement, please refer to Create Reverse Complement.