Extract Annotations

The Extract annotations tool makes it very easy to extract parts of a sequence (or several sequences) based on its annotations. Using a few steps it is possible to:

The output is a sequence list that contains sequences carrying the annotation specified (including the flanking regions, if this option was selected).

To extract annotations from a sequence:

        Toolbox | General Sequence Analysis (Image generalsequenceanalyses)| Extract Annotations (Image extract_annotations)

This opens the dialog shown in figure 10.6 that allows specification of which sequence to extract annotations from.

Image extractannotations_main_step2
Figure 10.6: Select one or more sequences to extract annotations from.

Click Next. At the top of the dialog shown in figure 10.7 you can specify which annotations to use:

Image extractannotations_main_step3
Figure 10.7: Adjusting parameters for extract annotations.

The sequence of interest can be extracted with flanking sequences:

The sequences that are created can be named after the annotation name, type etc:

Click Next if you wish to adjust how to handle the results. If not, click Finish.