Configuring the selected post processing tool
To configure the selected post processing tool we should provide input data and values for required parameters. Please observe that at the bottom of the post processing configuration menu seen in Fig. 8.3 the menu section Map user parameters to post processing parameters lists all parameters already defined for the external application (in this example, the in and out parameters). These can be re-used for the post processing tool by mapping them directly to either input data or specific parameters of the selected tool. This is done by configuring the mapping using the drop-down menu next to the parameter name. The mapping of a parameter to another is constrained by the type compatibility of the parameters, so not all mappings will be possible for a parameter but only those that make sense based on the type of the parameter.
Subsections