Per-region statistics

In addition to the summary report, you can see coverage statistics for each targeted region. This is reported as a track, and you can see the numbers by going to the table (Image table) view of the track. An example is shown in figure 27.6:
Chromosome
The name is taken from the reference sequence used for mapping.
Region
The region of the
Name
The annotation name derived from the annotation (if there is additional information on the annotation, this is retained in this table as well).
Target region length
The length of the region.
Target region length with coverage above...
The length of the region that is covered by at least the Minimum coverage level provided in figure 27.1.
Percentage with coverage above...
The percentage of the positions in the region with coverage above the Minimum coverage level provided in figure 27.1.
Read count
Number of reads that cover this region. Note that reads that only cover the region partially are also included. Note that reads in over-lapping pairs are counted individually (see figures 27.6 and figure 27.7).
Base count
The number of bases in the reads that are covering the target region. Note that bases in overlapping pairs are counted only once (see figures 27.6 and figure 27.7).
%GC
The GC content of the region.
Min coverage
The lowest coverage in the region.
Max coverage
The highest coverage in the region.
Mean coverage
The average coverage in the region.
Median coverage
The median coverage in the region.
Zero coverage bases
The number of positions with no coverage.
Mean coverage (excluding zero coverage)
The average coverage in the region, excluding any zero-coverage parts.
Median coverage (excluding zero coverage)
The median coverage in the region, excluding any zero-coverage parts.

Image targeted_table
Figure 27.6: A track list containing the target region coverage track and reads track. The target region coverage track has been opened from the track list and is shown in table view. Detailed information on each region is displayed. Only one paired read maps to the region selected.

Image targeted_table_pairs_disconnected
Figure 27.7: The same data as shown in figure 27.6, but now the Disconnect paired reads option in the side-panel of the reads track has been ticked, so that the two reads in the paired read are shown disconnected.